The following models are required to build ATLAS 3D.
| Name | Qty. | Description | Model |
|---|---|---|---|
| Camera Arm | 1 | STL | |
| Camera Bracket | 1 | STL | |
| Camera Case Back | 1 | STL | |
| Camera Case Front | 1 | STL | |
| Camera Shaft | 1 | STL | |
| Frame Connector | 6 | STL | |
| Frame Section 2 | 4 | STL | |
| Left Laser Arm | 1 | STL | |
| Right Laser Arm | 1 | STL | |
| Left Frame Section 3 | 1 | STL | |
| Right Frame Section 3 | 1 | STL | |
| Left Laser Holder | 1 | STL | |
| Right Laser Holder | 1 | STL | |
| RPI Cable Carrier | 4 | STL | |
| Crossbar | 5 | STL | |
| Camera Tower | 1 | STL | |
| Camera Tower Front Plate | 1 | STL | |
| Table Coupler | 1 | Updated 2015-06-10 | STL |
Raspberry Pi 2 and Raspberry Pi 1 Model B+ users need to print the below two models.
| Name | Qty. | Description | Model |
|---|---|---|---|
| RPI 2 and B+ Case Lower | 1 | Lower part of case for Pi 2 and Pi B+ | STL |
| RPI 2 and B+ Case Upper | 1 | Upper part of case for Pi 2 and Pi B+ | STL |
Raspberry Pi 1 Model B users need to print the below two models.
| Name | Qty. | Description | Model |
|---|---|---|---|
| RPI 1 Model B Case Lower | 1 | Lower part of case for Pi 1 Model B | STL |
| RPI 1 Model B Case Upper | 1 | Upper part of case for Pi 1 Model B | STL |
Only one of the following turntables needs to be printed.
The following models are either optional or alternatives models.
| Name | Qty. | Description | Model |
|---|---|---|---|
| Checkerboard Calibration Item | 1 | This model is used for checkerboard-based autocalibration | STL |
| Checkerboard Pattern | 1 | Attach this pattern to the checkerboard calibration item. | |
| Calibration Item | 1 | This model is used to assist in manual calibration of the ATLAS 3D scanner. | STL |
| Camera Bracket No Support | 1 | STL | |
| Left Camera Tower | 1 | Left side of the camera tower model for printers with small build volumes. | STL |
| Right Camera Tower | 1 | Right side of the camera tower model for printers with small build volumes. | STL |